Plan the boundaries
Start by deciding what each clip needs to contain. If you are extracting an interview answer, leave enough of the question to make it understandable. To separate meetings or lectures recorded back to back, cut at the handoff and keep any introduction that identifies the next part. Keep the full recording available while you make the copies.
SCRIBERFLO’s splitter gives you manual cut points and fixed time intervals. Manual points are best when the cut needs to follow speech or a topic boundary. Time Intervals are useful for making uniform review chunks. The current Silence Detection option proposes evenly spaced cuts, so use manual cuts when the positions need to follow actual pauses.
Split a recording and check both sides of each cut
Load an authorized copy
Open the Audio Splitter and add your audio. Select Load beside the file and wait for the waveform and duration. Play around each intended boundary. A flat-looking area can still contain a quiet breath or consonant, so use the waveform as a guide and rely on playback for the final position.
Add a point or choose a spacing
For Manual Split Points, move the playhead just after a phrase ends and select Add Split. Listen before and after it. Add more points in order as needed. For Time Intervals, choose a repeatable interval and expect the last clip to be shorter when the length is not an exact multiple.
Build the segments
Choose Split Audio and review the start and end times in the results. Very short segments under half a second are skipped by the current tool. If you meant to keep an opening or closing breath, make sure the surrounding segment is long enough to include it.
Download and play the outputs
Download a WAV for a single result or use Download All for a ZIP of the WAV files. Open the files after extraction. Check the first and last words around every cut you intend to share. Name the files in chronological order and record each clip’s start in the original.
Review the decision to split
If you only need one excerpt, use two bounds around it and download the relevant result. For a conversation with two people on the same audio track, cuts make shorter clips. They do not separate overlapping speakers into isolated tracks. If you need a transcript of the whole discussion, using the original can simplify timing and speaker review.
Repeated voiced sounds at a cut can usually be fixed by shifting the point into the pause and downloading again. Be especially careful with the last syllable before the split. When clips are headed to a publication workflow, listen to the sequence after joining them or adding them to the edit.
Common splitting questions
Will the WAV clips be smaller in total?
The splitter exports WAV. Re-encoding a compact MP3 as WAV can make the total output larger even when each segment is short. Use the compressor afterward if the delivery format needs a smaller MP3.
What happens if a cut is inside a sentence?
Each clip starts or ends at the position you selected. Move the point into a gap, then check the tail of the first clip and the opening of the next one.
Where do timestamps start after I upload a clip?
They are relative to the uploaded clip. Save its original start time if someone needs to find the same passage in the full recording later.
