Identify the noise you can hear
Listen to a pause and then a sentence. A fan, steady buzz, or low rumble can often be reduced. A nearby voice speaking at the same time as your speaker, a clipped microphone, or heavy room echo needs a different response. If there is an isolated microphone track, compare it before spending time adjusting a noisy mix.
Choose a difficult passage with both a pause and quiet speech. Put on headphones and note its timestamp so each comparison starts in the same place. Preserving intelligible words is usually worth leaving a little background noise.
Run one pass and compare it with the source
Add a working copy
Open the Audio Noise Reduction tool and add a copy of the audio file. Keep the source in its original format. If the file is sensitive, confirm the tools and handling rules approved for that recording before using an online workflow.
Make an Auto Mode reference
Leave Auto Mode on for the first pass, choose Reduce Noise, and download the resulting MP3. The preset combines filters that reduce low and high frequencies and a gate that attenuates quiet audio. It can also affect quiet speech, so treat the first output as a comparison copy.
Try a lighter Manual pass
If the Auto result softens word endings or makes pauses sound abruptly gated, turn Auto Mode off and try one change at a time. For low rumble, set Noise Reduction Intensity to 0.3, Sensitivity to 0.4, and Audio Smoothing to 0.2. With these settings the current tool applies a high-pass filter without adding the gate. Start this pass from the source.
Listen back at a comparable volume
Check the same passage in the original, Auto, and Manual versions. Listen for the start of a soft sentence, breaths you want to keep, and the consonant at the end of a line. Use the version that preserves the speaker best, then check a different spot to make sure the choice travels across the recording.
Know when cleanup is the wrong next step
If a pause sounds cleaner and speech sounds worse, try a lighter pass or keep the original. If a cough or bump covers a single word, compare an alternate track or mark it as uncertain in your transcript. Wide filtering cannot recover sound the microphone never recorded. For a new recording, changing the mic position or moving away from the noise can save more time than processing.
Keep the source if the recording will support a quote, a research observation, or a hearing review. If a cleaned copy helped you find a passage, check the passage again in the original before relying on it.
Common noise reduction questions
What does the tool download?
The cleaned file is an MP3. Keep the original alongside it if you might make another pass or need to check an unclear passage later.
Should I increase Sensitivity when a speaker is quiet?
In the current Manual mode, sufficiently high Sensitivity adds a gate. That can lower the level between words and weaken quiet speech. Compare one setting at a time and listen to the softest speaker.
Can I remove another voice from the same microphone?
Steady background noise and competing speech are different problems. Try an isolated track or alternate recording when you need to separate voices. Keep unclear lines marked for review when neither source resolves them.
